Flex 2100 with Check software

 
-  Weighing unit using passive sense, 1600 Samples per second
- High-resolution 5,7”color TFT touch screen
- Panel Mount

AC power supply:
-100 - 240Vac 50/60Hz 20W max.
 
Inputs:
- 8 Inputs  Optical isolated, 1 common, 18 - 28 Vdc PNP or NPN
- Input 1 = Start
- Input 2 = Stop
- Input 3 = Start check

- Input 4 = Not used
- Input 5 = Not used
- Input 6 = Not used
- Input 7 = Not used
- Input 8 = Not used
 
Outputs:
- 8 Outputs Isolated PhotoMOS, 1 common, max. 35 Vdc or Vac, 0.5A nominal, 1A Surge PNP or NPN
- Output 1 = Check OK
- Output 2 = Reject low
- Output 3 = Reject high
- Output 4 = Check busy

- Output 5 = Run mode
- Output 6 = Check Ready
- Output 7 = Not used
- Output 8 = Not used

- Passive analog output, the analog output is used for the belt speed of the weighing section

0 - 20 mA
4 - 20 mA
0 - 24 mA
4 - 24 mA
0 - 10 V (with a 500 ohm resistor)


- For Certified or Industrial applications
- Ethernet, Profibus, CANbus, RS232 and RS422 communication


Communication can be used for:
Ethernet:
- Communicate with PC
- Communicate with PLC (Ethernet IP, Fins and Modbus TCP protocol)
- Communicate with other PENKO devices with Ethernet (PENKO TP protocol)
- Printing

Profibus (slave):
- Communicate with PLC
- Communicate with other Profibus devices which are set as Master.

CANbus:
- Communicate with other PENKO devices

RS232:
- Communicate with PC
- Communicate with PLC with ASCII, NPV Slave, HL Viewteq, HL PLC, Modbus RTU and Modbus ASCII
- Communicate with other PENKO devices
- Printing

RS422:
- Communicate with PC
- Communicate with PLC with ASCII, NPV Slave, HL Viewteq, HL PLC, Modbus RTU and Modbus ASCII
- Communicate with other PENKO devices
- Printing